Question
Customer tried to clear CMOS but made a mistake.  Customer shorted the JBT1 but with the coin battery in.  Now the M/B is beeping but no image.
Print
Answer
In this case, the battery is drained out.  Please replace with a new CR2032 battery to M/B and retry CMOS clear routine.
1. Shutdown and unplug power cord.
2. Remove coin battery for 5minutes.
3. Use metal (screw driver,) to short two JBT1 pads for 10 seconds.
4. Put back coin battery and retest.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
N A F F
FAQ ID:
40039
Related Category / Keyword:
BIOS:
AMI BIOS
Date Posted:
05/17/24
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region