Yes, they do. Please follow the steps below to complete installation if you install NT4.0 into SCSI, SATA or RAID drive. If you are using IDE drive, please ignore these steps.
1. Go into BIOS setup.
2. Under Advanced -> PCI/PnP Config, set [ NT4 Installation Workaround] to enable
3. Save and exit from BIOS setup.
4. Place Microsoft NT4 CD into CD-ROM.
5. Press key couple times after CD boots and displays "Setup is inspecting your computer's hardware config..."
6. Follow up the sequence to load drivers from floppy disk and complete HDD partitioning.
7. NT4 Setup copied system files and prompts users to press key to reset.
8. Go into BIOS setup again after Step 7. Remember to remove NT4 CD from CDROM.
9. Set [disabled] for Advanced -> PCI/PnP Config -> NT4 Installation Workaround: item.
10. Save and exit from BIOS setup.
11. Continue subsequent NT4 installation.