Question
I purchased the Super Micro C2SBC-Q mother board for its compatibility with Linux Red Hat 5. I am having trouble with Red Hat 5 seeing the controller. Is the C2SBC-Q not compatible with Red Hat 5, or do you any suggestions to help this OS installation?
Print
Answer
1. To run Linux Hed Hat 5.0, you must select Adaptec Codebase Firmware inside the BIOS setting.

2. Enter to Adaptec Raid BIOS setup utility configure the raid level you want.

3. If you have IDE CD-ROM or DVD-ROM drive that connect to on-board, you must specify the ITE controller driver (check the ITE chipset Number on the motherboard) than download the correct Adaptec RAID driver.

https://www.supermicro.com/wdl/driver/ATA/ITE/

https://www.supermicro.com/wdl/driver/SATA/Adaptec_ICH9R/Linux/17706/Redhat/
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
Q 9 C 4
FAQ ID:
8632
Related Category / Keyword:
BIOS:
BIOS Setting
Operating Systems:
Linux OS
Other:
Driver
Date Posted:
02/20/09
Code:
DL
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region