Question
I install AOC-SLG3-2M2 on X11SSH-LN4F, the system stopped at POST screen and continuous beep. If DIMMA1 is not populated with memory, the system can boot up without any issues. Could you please help advise?
Print
Answer
This is due to hardware limitation as the result of SMBus address conflict between DIMMA1 and the M.2 AOC. Please try either one of below workarounds:


1. Disable the Jumpers of SMB to PCI Slots (JI2C1/JI2C2), go to BIOS PEG Port Configuration >> change SLOT5 Bifurcation to [x4x4].
2. Or remove the memory from DIMMA1 slot.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
M C P K
FAQ ID:
26714
Related Category / Keyword:
Peripherals:
AOC
Date Posted:
10/24/17
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region